-
Welcome to H4O! For a reduced ad experience, please login or register with the forum.
-
The Swap Meet is not a regulated market, and buyers/sellers are not screened. Please do your homework before agreeing to anyone for any purchases or sales. If you have any questions about the user, please contact @Alrock via private message and I will attempt to provide any relevant information about the person, including location based on IP address. This is not a guarantee or promise of delivery but the addtional information may be helpful to you in your transaction. There are no guarantees here so use your judgement. Consider payment options like PayPal that have recourse (only when treated as a sale, and not as % between friends). Scammers will often use Zelle or ask for PayPal between friends because you cannot reclaim the money in the event of fraud or non-delivery. If a user has just joined and/or has few posts they should be viewed very cautiously.
WTS Zmag chrome hood louver
- Thread starter 4u33er
- Start date
SGT-Wright
Well-Known Member
- Messages
- 356
- Location
- Washougal WA
I see that you cut through the hood to vent the engine. How is that working out? What does that louver weigh, I might be interested. One more question, how does it attach? Tape, screws, or ???
Thanks
Thanks
It weights 22 lbs. It very high quality thick billet chrome aluminum. Its come with a nut and bolt with washers. The back uses existing holes on the hood from the factory plastic louver clip, the front two you need to drill a small hole under need so you can tighten the nut down, very easy takes 15 min tops.
The cut out on the hood is so far so good, I will need to monitor it more to report any updates on.
PM me an offer.
The cut out on the hood is so far so good, I will need to monitor it more to report any updates on.
PM me an offer.