What year is your h3? Looks like the rear door check is listed as 15286625 for the very first h3s build in 2005 and 15929238 for all h3s and h3ts built after that.
Watch out for the aftermarket fan clutches, I tried 2 non oem clutches and they both stuck out too far and hit the radiator. I would be surprised if they worked with an oem alpha setup.
H3 rear glass isn't flat. I have a project ongoing to replace the rear glass with a steel flip up access door and had to add a bit of curve to make it look good. Not saying flat glass wouldn't work bit I don't think it would look factory on a stretch project.
Can't believe this hasn't already sold... as someone who searched for a year or two for all of the alpha specific parts I know this is a steal even if the engine or trans needs work. If it were local to me I would buy it as a spare
I think that is related to a sensor in the master cylinder or abs module. Unfortunately I think that whole assembly on the firewall is replaced as a unit if it is the culprit.
I just did the same thing but made my own frame side mounts. Here are the bushing and tubes I used for reference and used the stock h3 leaf springs with them...
Oh and to give you some piece of mind I have since modified my core support so the top section near the radiator unbolts so I can lift the radiator straight up if I need to service it without having to pull the fan clutch. Granted I don't wheel as hard as you or do as much flexing but I have...
I think one signal goes from 0v to 5v and the other goes 5v to 0v as the pedal moves or something along those lines, as you mentioned as a failsafe. I think it is worth a shot but I expect you will get a pedal correlation code and probably limp mode. Buried in code somewhere are idle speed...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.