Cortinas316
Well-Known Member
- Messages
- 86
- Location
- san antonio tx
After seeing posts by Chad a while back with a hidden AR15 in the jack space in the rear door got me thinking. Of course I am going to do this too! Already ordered the quick fists for mounts but wanted a project while I waited. Came up with a way to hide a full size 1911 in a Hummer H3 middle console.
Went and got a sheet of 2" thick foam and cut it down to 3 squares measuring 6 1/2" by 5". Although you can make it larger I wanted some space in the back of the console for extra mags or misc crap.
Take the 3 blocks and used Elmer's spray glue to glue them together. Then used a pearing knife to cut a hole just large enough for the barrel In two of the three blocks. I left the bottom one without a hole so the barrel has a resting point.
After that dryed I used synthetic leather to wrap the block and made a slit with an exact knife where the while in the foam was. And WAHLAH! Here's the final result..
Next I'll post the AR15 mount build.
Went and got a sheet of 2" thick foam and cut it down to 3 squares measuring 6 1/2" by 5". Although you can make it larger I wanted some space in the back of the console for extra mags or misc crap.
Take the 3 blocks and used Elmer's spray glue to glue them together. Then used a pearing knife to cut a hole just large enough for the barrel In two of the three blocks. I left the bottom one without a hole so the barrel has a resting point.
After that dryed I used synthetic leather to wrap the block and made a slit with an exact knife where the while in the foam was. And WAHLAH! Here's the final result..
Next I'll post the AR15 mount build.