Search results

I haven’t ordered from them for some time but try Outfitter Design They make some good stuff. https://www.outfitterdesign.com/do-it-yourself-front-differential-bushing-kit.html

Welcome. Looks great.

Merry Christmas!

If the problem persists, try looking at the blower control module. I had never heard of the issue before but just did a repair a few months ago on my neighbors 2500 with a similar problem. Apparently it has affected multiple GM vehicles. Replacement module shown in this video did the trick.

I’ve had a YJ, a TJ and a plethora of XJs. Jeeps do Jeep things great and have ridiculous amount of support and parts available but there’s something about the H3. I get a lot of flack from the in-laws who all have Jeeps (5 & counting). It really gets them going when they have $100k into...

You’re heading the same direction I would go. No handle problems yet, knock on wood.

I’d love to have an Alpha H3T someday for many of the same reasons. Not in the cards today. It’ll be fun to see what upgrades you end up doing.

Schwarttzy does a great video of how he repaired his.

Best picture I have of mine. 45° up about 1/4". Just enough to clear the controller.

If it were me, I’d give these panels a good cleaning and use a light grit 3M scotchbrite (grey) to prep the shiny areas for clear, lightly getting the “faded” areas but not too much. A wipe down afterwards with a wax and grease remover will initially show you close to what it would look like...

I found a parts vehicle for cheap that had everything I needed & I used to work in the collision industry so nothing outside of my comfort zone.

Welcome

PM sent.

Looks great! I would have a hard time working on such a nice workbench.

I have a complete I-5 assembly off my parts vehicle you’re welcome to. I also have a dying/ dead 5.3 pump I’m replacing this week. No pulley for the 5.3 though.

+2

ECP radiator finally in. Cut out and rebuilt the lower core support for clearance and a little nip tuck on the upper core support to push the new much larger radiator forward one inch similar to what 06H3 did with his. Had the FJ60 steering box rebuilt by Red Head and replaced the Borgeson U...

Eventually I'll be swapping out for the ones in this link. https://barnes4wd.com/products/heavy-duty-centered-shackle-hanger-pair-3-inch-overall-width-for-2-1-2-inch-wide-springs

Great troubleshooting. Glad you figured it out.

I've watched your video. Planning on rebuilding the core support around it. I want to retain the factory fan and shroud.