LoJac963
Well-Known Member
- Messages
- 491
- Location
- Surprise, AZ
I'm curious how one can prevent any body panels from rusting after drilling into them. So for instance the E&G fender flares. The front isn't a big deal because the hood is fiberglass but the rear flares have to be drilled into the metal body.
I didn't know if just clear silicone all over the screw threads before screwing them in would suffice?
Any ideas?
Thanks in advance!
I didn't know if just clear silicone all over the screw threads before screwing them in would suffice?
Any ideas?
Thanks in advance!