rascole
Well-Known Member
- Messages
- 2,587
- Location
- Bellflower, CA
Here is my installation of the Scorpworks Bushing Front Diff Crossmember.
I have one word to describe this crossmember. Awesome. This was way easier then I had expected. I would recommend a small bottle jack and a rubber mallet. For what ever dumb reason, my wrench set did not come with a 18mm, it skips it, go figure. So make sure you have one before you start.
Here it is ready to be installed.
Some pictures before I turned a wrench. Mine was bad but not as bad as others.
My first problem, and only problem, was the passenger side outside bolt hits the A arm and would not slide out. I used my bottle jack to raise the A arm and the bolt slide right out.
And here it is, out with the old and in with the new.
I have one word to describe this crossmember. Awesome. This was way easier then I had expected. I would recommend a small bottle jack and a rubber mallet. For what ever dumb reason, my wrench set did not come with a 18mm, it skips it, go figure. So make sure you have one before you start.
Here it is ready to be installed.
Some pictures before I turned a wrench. Mine was bad but not as bad as others.
My first problem, and only problem, was the passenger side outside bolt hits the A arm and would not slide out. I used my bottle jack to raise the A arm and the bolt slide right out.
And here it is, out with the old and in with the new.