Welcome to the H4O - HUMMER 4x4 Off Road.

Search:

Type: Posts; User: f5moab

Page 1 of 20 1 2 3 4

Search: Search took 0.06 seconds.

  1. Replies
    9
    Views
    70

    Been many, many years since I actually handled...

    Been many, many years since I actually handled one, but I don't remember those two indents on the mag, and remember a metal clip attached to the side that went over the cartridges. But it has been a...
  2. Replies
    7
    Views
    236

    H3 When I had my H3 I mounted the rearview camera to...

    When I had my H3 I mounted the rearview camera to the top of the hitch. These photos are from my 2006 H3, taken in 2005.... Used an industrial zip tie primarily used for large air ducts. Did the same...
  3. Replies
    8
    Views
    166

    https://i.imgur.com/y0fB1wl.gif Doesn't sound...

    https://i.imgur.com/y0fB1wl.gif

    Doesn't sound like you have much choice if is leaking as bad as being implied!
  4. H3 The open differential allows the wheels to turn...

    The open differential allows the wheels to turn at different rates of speed while the axle continues to transmit the driving force. This prevents tire scuffing when going around corners and premature...
  5. Replies
    34
    Views
    958

    https://i.imgur.com/fMPetVo.jpg

    https://i.imgur.com/fMPetVo.jpg
  6. Thread: My dog, Daisy

    by f5moab
    Replies
    10
    Views
    247

    Sorry. I remember Daisy. I know what you are...

    Sorry. I remember Daisy. I know what you are going through, be strong, it's tough.

    A friend sent me this a few years ago....

    25311
  7. Had a '13 and '15 Silverado and now GMC and...

    Had a '13 and '15 Silverado and now GMC and never, I say NEVER had any shakes due to the vehicle. The '13 and current GMC were equipped with 20" tires, the '15 had 18" tires. And all were or...
  8. Local... NEW 2019 GMC SIERRA 1500Crew Cab...

    Local...
    NEW 2019 GMC SIERRA 1500Crew Cab Standard Box 4-Wheel Drive SLE
    $38,700
  9. Replies
    9
    Views
    279

    Doubt if it was the LEDs, I had them in my H3 for...

    Doubt if it was the LEDs, I had them in my H3 for years and only added load resistors for the flashers.
    Also, cannot figure out how a large number of codes would destroy the BCM.
    I would suspect...
  10. Replies
    10
    Views
    330

    Lived in TN for seven years, that's called a...

    Lived in TN for seven years, that's called a redneck exit. Too common. Good thing it was not worse and involved dented body panels.
  11. Replies
    2
    Views
    144

    Before the dream cruise, we used to cruse that...

    Before the dream cruise, we used to cruse that same stretch of Woodward back when I was in college (and a little when in HS). Sometimes wonder if Teds is still at the end, and is the totem pole still...
  12. Thread: Dashboard

    by f5moab
    Replies
    1
    Views
    577

    Posted twice once as a dashboard and now as a...

    Posted twice once as a dashboard and now as a instrument panel....I assume you mean the instrument cluster? And what isn't working.....
  13. Thread: C8 Pictures

    by f5moab
    Replies
    7
    Views
    590

    No manual trans....

    No manual trans....
  14. Because they wanted to, and it was sold as a full...

    Because they wanted to, and it was sold as a full time 4x4 system; so all who purchased it knew what it.
  15. Replies
    1
    Views
    186

    And to help keep noise out!

    And to help keep noise out!
  16. Thread: Tech 2 clone

    by f5moab
    Replies
    22
    Views
    5,223

    If I could have turned off the TPMS on the H3 I...

    If I could have turned off the TPMS on the H3 I would have with a genuine 100% GM Tech 2. The TPMS system is designated by federal regs via the TREAD act (tread not for tires but an acronym for...
  17. Before punching a hole in an oil filter; make...

    Before punching a hole in an oil filter; make sure to loosen it even a tenth of a turn. I have seen oil filter cross threaded to the point that to remove may be more than a backyard mechanic wants to...
  18. Thread: H3 Paint Code

    by f5moab
    Replies
    5
    Views
    261

    H3 When I used to run them for people it would take...

    When I used to run them for people it would take me a few minutes to sign onto the computer system, type in a VIN number and wait a second or two, then send to print. Dealers are normally always in...
  19. Thread: H3 Paint Code

    by f5moab
    Replies
    5
    Views
    261

    H3 Have a dealer run a detailed billing report for...

    Have a dealer run a detailed billing report for the vehicle. That will contain all the rpo codes, paint codes, etc., for the vehicle. When I worked for GM I could run them on any vehicle they made so...
  20. I'll go with a Fumoto, use someone else's...

    I'll go with a Fumoto, use someone else's driveway, and still use a lot of cardboard for when you accidentally spill the container sliding it out from under the vehicle.
  21. Replies
    9
    Views
    331

    H3 https://i.imgur.com/y0fB1wl.gif

    https://i.imgur.com/y0fB1wl.gif
  22. Yep, I always believe the tech at the...

    Yep, I always believe the tech at the shop.:giggle: A reset does not add any greater damage to the actuators than their normal use by the controller during you daily travels and changing the AC...
  23. Agree, I do!

    Agree, I do!
  24. Disconnecting the battery will "tear" up the...

    Disconnecting the battery will "tear" up the actuators? Please explain.....
    Will disconnecting the battery possible (POSSIBLY) cause the actuators to unsink....maybe. However, when the AC control...
  25. https://i.imgur.com/y0fB1wl.gif I have seen...

    https://i.imgur.com/y0fB1wl.gif

    I have seen technicians do wonders with a plastic welder, and I have also done some plastic repairs that I was amazed lasted for years with JB Weld.

    If the part...
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4
Logout