Welcome to the H4O - HUMMER 4x4 Off Road.

Search:

Type: Posts; User: f5moab

Page 1 of 20 1 2 3 4

Search: Search took 0.06 seconds.

  1. Had a '13 and '15 Silverado and now GMC and...

    Had a '13 and '15 Silverado and now GMC and never, I say NEVER had any shakes due to the vehicle. The '13 and current GMC were equipped with 20" tires, the '15 had 18" tires. And all were or...
  2. Local... NEW 2019 GMC SIERRA 1500Crew Cab...

    Local...
    NEW 2019 GMC SIERRA 1500Crew Cab Standard Box 4-Wheel Drive SLE
    $38,700
  3. Replies
    9
    Views
    212

    Doubt if it was the LEDs, I had them in my H3 for...

    Doubt if it was the LEDs, I had them in my H3 for years and only added load resistors for the flashers.
    Also, cannot figure out how a large number of codes would destroy the BCM.
    I would suspect...
  4. Replies
    10
    Views
    272

    Lived in TN for seven years, that's called a...

    Lived in TN for seven years, that's called a redneck exit. Too common. Good thing it was not worse and involved dented body panels.
  5. Replies
    2
    Views
    116

    Before the dream cruise, we used to cruse that...

    Before the dream cruise, we used to cruse that same stretch of Woodward back when I was in college (and a little when in HS). Sometimes wonder if Teds is still at the end, and is the totem pole still...
  6. Thread: Dashboard

    by f5moab
    Replies
    1
    Views
    302

    Posted twice once as a dashboard and now as a...

    Posted twice once as a dashboard and now as a instrument panel....I assume you mean the instrument cluster? And what isn't working.....
  7. Thread: C8 Pictures

    by f5moab
    Replies
    7
    Views
    432

    No manual trans....

    No manual trans....
  8. Because they wanted to, and it was sold as a full...

    Because they wanted to, and it was sold as a full time 4x4 system; so all who purchased it knew what it.
  9. Replies
    1
    Views
    172

    And to help keep noise out!

    And to help keep noise out!
  10. Thread: Tech 2 clone

    by f5moab
    Replies
    22
    Views
    5,107

    If I could have turned off the TPMS on the H3 I...

    If I could have turned off the TPMS on the H3 I would have with a genuine 100% GM Tech 2. The TPMS system is designated by federal regs via the TREAD act (tread not for tires but an acronym for...
  11. Before punching a hole in an oil filter; make...

    Before punching a hole in an oil filter; make sure to loosen it even a tenth of a turn. I have seen oil filter cross threaded to the point that to remove may be more than a backyard mechanic wants to...
  12. Thread: H3 Paint Code

    by f5moab
    Replies
    5
    Views
    216

    H3 When I used to run them for people it would take...

    When I used to run them for people it would take me a few minutes to sign onto the computer system, type in a VIN number and wait a second or two, then send to print. Dealers are normally always in...
  13. Thread: H3 Paint Code

    by f5moab
    Replies
    5
    Views
    216

    H3 Have a dealer run a detailed billing report for...

    Have a dealer run a detailed billing report for the vehicle. That will contain all the rpo codes, paint codes, etc., for the vehicle. When I worked for GM I could run them on any vehicle they made so...
  14. I'll go with a Fumoto, use someone else's...

    I'll go with a Fumoto, use someone else's driveway, and still use a lot of cardboard for when you accidentally spill the container sliding it out from under the vehicle.
  15. Replies
    9
    Views
    303

    H3 https://i.imgur.com/y0fB1wl.gif

    https://i.imgur.com/y0fB1wl.gif
  16. Yep, I always believe the tech at the...

    Yep, I always believe the tech at the shop.:giggle: A reset does not add any greater damage to the actuators than their normal use by the controller during you daily travels and changing the AC...
  17. Agree, I do!

    Agree, I do!
  18. Disconnecting the battery will "tear" up the...

    Disconnecting the battery will "tear" up the actuators? Please explain.....
    Will disconnecting the battery possible (POSSIBLY) cause the actuators to unsink....maybe. However, when the AC control...
  19. https://i.imgur.com/y0fB1wl.gif I have seen...

    https://i.imgur.com/y0fB1wl.gif

    I have seen technicians do wonders with a plastic welder, and I have also done some plastic repairs that I was amazed lasted for years with JB Weld.

    If the part...
  20. Only hummer i see is the front grill and that...

    Only hummer i see is the front grill and that could be from a heep too. Reminds me more of a Unimog than a Hummer.
    But made in Russia? Not even if I had money to throw away.
  21. I had 62K on my H3 when I sold it and it lived in...

    I had 62K on my H3 when I sold it and it lived in Moab for almost six years and also towed a large PU camper in the mountains of UT, CO, ID, WY, MT, and a few other places. Not only did I travel...
  22. Replies
    2
    Views
    264

    Wow...A new set is only $200.00 from Helm.

    Wow...A new set is only $200.00 from Helm.
  23. First thing I installed on both of my H3s with...

    First thing I installed on both of my H3s with the Pioneer entertainment heads. And if you are single or connect a trailer by yourself, it makes it so much easier.
  24. Replies
    2
    Views
    246

    Gone!

    Gone!
  25. Replies
    4
    Views
    297

    H3 Don't shake it and it stops. Thanks for the...

    Don't shake it and it stops. Thanks for the info.:giggle:

    Two sided tape should work great, it's just a pressure blow by valve.
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4
Logout