Search:

Yes, and GM turned them away due to their limited production numbers and the fact they wanted GM to make some expensive modifications to the engine compartment and GM said NOPE. Due to limited volume...

Video is only what he thinks, what he likes, what his opinions are. GM will really listen to them....NOT! But good for a life during a blizzard.

What makes you think you have a bad yaw sensor? You don't say.

Are you saying on a 06 there are four wires going into the sensor? If yes, what are the colors. The original sensor used on 06 H3s...

If you had a leak in the roof it the headliner would show it and would not contain the water. Since the noise is more prevalent with the seats down, pay special attention to the rear door. But could...

Used to spend a lot of time in Kentwood (outside of GR).:giggle:

Some reading that might help....
https://i.imgur.com/rD2hFZ2.jpg


https://i.imgur.com/K0QPF3a.jpg

Which relay; Headlamp or Hi/Lo Beam? Just switch relays around (if other relays in box with same part number) to see problem goes with relay (then replace) if not, relay is ok. Could also be a...

Aftermarket systems are a pain in the arse to troubleshoot and made so more by the fact very few people have a schematic for them. And yes, those damn scotchlock connectors should be outlawed...

Contact a GM dealer and have them look the sensor up in the electronic parts catalog. Part numbers can change from year to year for many reasons.

Yes. It's a United States Federal Law; I am not familiar with other countries and their laws. I believe all H3s sold in Europe came with amber rear turn signal lenses due to the laws in "some"...

Not going to read a book since I am very familiar with the Firestone/Ford Explore fiasco and the idiocy of Ford Motor. I was an occasional witness for some of the TREAD act meetings, and viewed a lot...

TP sensors will go into sleep mode after a spec'ed time after tire rotation and only update the BCM about every minute or two (can't remember the exact spec). They will turn On in full power mode...

If it was my H3 (and I know it isn't) I would do some bondo work, maybe add a bed liner strip in the front location, just to cover the old position of the lamps, and then install an LED light bar,...

There are always caveats.:thumbs:

The BCM (Body control module) on the H3 is only capable of reading four TP sensors.

Now, from memory...

First year (2006) H3s were equipped from the...

Dark garage and black light....sounds a bit kinky; speedy!:giggle:

Even if you do a five tire rotation and have only four sensors, the light will not turn On; provided the pressures are ok. The system will see the spare tire with the sensor. However, if looking for...

I could pull up the procedure on my other old windows 7 laptop; however, from memory it does entail removing the entire dash assembly; not the cluster and that is one major job. If it was a dash...

One thing you might want to look at closely is the top header on the radiator, they are noted to crack and allow leakage (small amount) and due to the H3's front skid plate, it can drop on to the...

I'll take a SWAG and say it is a ground wire. But there is an easy way to confirm. Use a voltmeter to test for power on the circuit, and if no voltage, then to confirm it is ground, use the Ohm...

Not sure what you are asking and not sure what the picture is of; other than it is a JVC CD changer controller....(CD Changer?)

No heater core, no effective defrost.
Other than condensation on window and coolant smell through the vents, another sign is coolant leaking into the pass compartment. But if man made it will...

Underhood junction block is ok, at the rear, in the trailer wiring package (Light Green wire), at the trailer connector (Light green wire, center pin). There is also a backup lamp circuit running...

Just sent you a private message!

Glad to see you are still kicking around.....

If needed, here is an old link on how to clean switches....
https://www.hummer4x4offroad.com/forum/showthread.php/87-Serv-4wd?highlight=buttons