Welcome to the H4O - HUMMER 4x4 Off Road.

Search:

Type: Posts; User: Mr_Rich

Page 1 of 20 1 2 3 4

Search: Search took 0.03 seconds.

  1. Replies
    1
    Views
    126

    2009 Hummer H3T base

    Found it...

    https://www.cargurus.com/Cars/l-Used-Hummer-H3T-d1524#listing=269041243
  2. Replies
    11
    Views
    470

    I did a search online and found "my" truck very...

    I did a search online and found "my" truck very quickly. Seems it has made its way to Las Vegas, NV at a dealer there. It looks pretty much like I sold it except for maybe a little more polish. ...
  3. Replies
    2
    Views
    176

    WTS 25860Pics

    25860Pics
  4. Replies
    11
    Views
    470

    I miss my 3T. It turned in to my DD for many...

    I miss my 3T. It turned in to my DD for many years and I piled on a lot of miles. It was my retirement gift to myself back in '09 and it kind of symbolized that fact in my mind every time I drove...
  5. Replies
    2
    Views
    176

    WTS 2008 H3 Service Manuals

    I have the full set of GM Service Manuals for sale. These are the three volumes for a 2008 H3. $200 shipped.
  6. Replies
    11
    Views
    470

    I'm going back through the history and...

    I'm going back through the history and maintenance history of my truck. There were common replacement parts like the throttle body and PS pump. Other than that it's been a great vehicle. My...
  7. Replies
    11
    Views
    470

    My H3T time is up

    I've been fighting the idea of letting my 3T go. It had to happen. I'm not getting younger and I've enjoyed owning this truck for the last ten years. It was 1 of 56 with a manual trans and I think...
  8. Replies
    18
    Views
    8,623

    H3T I don't recall a Torx bolt that you could be...

    I don't recall a Torx bolt that you could be referring to. ??? I removed the air box when I did the job. I'm pretty sure I remember that but not much else.
  9. Replies
    15
    Views
    744

    H3 I use a Dremel tool and start a hole in the top...

    I use a Dremel tool and start a hole in the top of the broken bolt. A reverse twist drill bit (with a drill in reverse) should grab the remaining part of the bolt and spin right out. It has worked...
  10. First off I would check voltage at the battery...

    First off I would check voltage at the battery with a voltmeter. Turn on the different accessories like radio, heater (switch positions 1-4),wipers, and headlights to load the system and see what...
  11. Good read. I agree about the Atlas engines. I...

    Good read. I agree about the Atlas engines. I remember my '86 Jeep Comanche with a 2.8L feedback carb'ed engine. Ran great and handled great but no power for carrying any kind of load. My 3T with...
  12. Replies
    21
    Views
    2,519

    This discussion got my curiosity up and I...

    This discussion got my curiosity up and I searched Ebay. There are several original H3 flywheels available for sale. I saw an H3 flexplate for sale that was pictured and it showed eight mounting...
  13. Replies
    21
    Views
    2,519

    How many miles on your vehicle? Depending on...

    How many miles on your vehicle? Depending on your driving habits modern clutches/ clutch components can last a long time. Some GM vehicles use a sealed pilot bearing and they can last forever. ...
  14. Replies
    5
    Views
    288

    Just for reference I bought a new Dodge Ram 2500...

    Just for reference I bought a new Dodge Ram 2500 to pull a travel trailer. I've had to get used to the fact that the engine is designed to run in the 210-215 degree range. Seems too hot considering...
  15. Replies
    7
    Views
    510

    H3 Power steering PUMP, not the high pressure hose. ...

    Power steering PUMP, not the high pressure hose. I think that is a common replacement item on our trucks once the mileage gets up there.
  16. Funny thing is that PS pump in my '89 Chevy K1500...

    Funny thing is that PS pump in my '89 Chevy K1500 has survived for the last thirty years, and four engine swaps using the red PS fluid. My 3T required the clear PS fluid and using the red PS fluid...
  17. When my PS pump failed I no longer had power...

    When my PS pump failed I no longer had power assist on the steering; heavy manual steering feel. The GM pump I bought was made in Spain, IIRC. It's an easy enough job to replace if your familiar...
  18. Replies
    5
    Views
    331

    H3 The TPS is integral to the throttle body. If you...

    The TPS is integral to the throttle body. If you want to replace the TPS replace the throttle body. There's no trick to it; I replaced mine a couple of years ago after my truck neared 100K miles. ...
  19. Replies
    22
    Views
    1,736

    I cut ~2" Velcro straps from a roll that sells in...

    I cut ~2" Velcro straps from a roll that sells in hardware stores. I folded the Velcro over each elastic loop. It tightened up the clips perfectly and was a cheap fix-it.
  20. Thread: C8 Pictures

    by Mr_Rich
    Replies
    7
    Views
    1,198

    I with you on that statement Craig. I think the...

    I with you on that statement Craig. I think the fact that we didn't have the trans cooler in the radiator helped keep our engines cooler traveling in hot weather. I think that was a big plus as...
  21. I sold my home in April. There were changes I...

    I sold my home in April. There were changes I had to make and I knew it was coming once I reached 65; down-sizing. My 3T was great with home life, but didn't really fit in with plans for a new...
  22. Replies
    9
    Views
    480

    H3 I don't want to mislead you into thinking the...

    I don't want to mislead you into thinking the AX-15 is an upgraded trans. The AX-15 IS the stock Hummer man trans and is used in a variety of GM vehicles also. I think the ad I'm talking about is...
  23. Replies
    9
    Views
    480

    H3 Here's a link with some good info;...

    Here's a link with some good info; https://www.novak-adapt.com/ They regard the AX-15 as one of the best man trans installed in Jeeps. I saw an ad for an upgraded trans that might fit but I don't...
  24. Replies
    12
    Views
    791

    The knock sensors (2) are located underneath the...

    The knock sensors (2) are located underneath the intake manifold. When I swapped out the LS1 (Gen III) engine in my '98 Firebird I pinched one of the knock sensor wires on the first sensor when I...
  25. Replies
    40
    Views
    2,115

    You have several differing opinions on this...

    You have several differing opinions on this subject. I mentioned my '69 Firebird because I think the seats would've been easier on that car than the Hummer. One item that was mentioned was if the...
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4
Logout