-
Welcome to H4O! For a reduced ad experience, please login or register with the forum.
Cross member bushings
- Thread starter CarlosSA
- Start date
08H3
Well-Known Member
- Messages
- 1,315
- Location
- United States
I have the Outfitter Designs kit. I'm very pleased with them. Also ran a simple suspension bushing in the crossmember for many miles without any issue prior to that.
rascole
Well-Known Member
- Messages
- 2,587
- Location
- Bellflower, CA
rascole
Well-Known Member
- Messages
- 2,587
- Location
- Bellflower, CA
JPaul
Well-Known Member
- Messages
- 2,401
- Location
- Way up north, UT
I'm using the Outfitter Design cross member bushing set as well. I think it works great. Installation isn't bad at all with a torch and time to remove the old bushings. But if you need a replacement part then expect to have to buy a whole other kit. They're kind of stingy with selling you only part of the kit, even if it's to make it a complete set again.
The Scorpworks is great too and they are a forum sponsor, but it's a bit expensive, especially when factoring in shipping him your crossmember and everything. And if he doesn't have one ready to go then you need to send him your crossmember first, so there is downtime with it. He fixes up your crossmember real nice though, welds up any cracks and reinforces the ends so that they don't crack again in the future, and repaints it too I think.
The Scorpworks is great too and they are a forum sponsor, but it's a bit expensive, especially when factoring in shipping him your crossmember and everything. And if he doesn't have one ready to go then you need to send him your crossmember first, so there is downtime with it. He fixes up your crossmember real nice though, welds up any cracks and reinforces the ends so that they don't crack again in the future, and repaints it too I think.