Recent content by USMC_315

Thanks buddy!

Please tell me there's a build thread or some photos/videos you can share of the process... Did you do all that yourself?

I think Schwartzy sells them on his website. I bought a few a while back and replaced mine. Although I did the driver side lights, so it might not be the same bulb

Hey everyone, I'm trying to figure out what the official AM General/GM GVWR is. I've scoured google, but can only come up with answers from car review sites and the like. Every number I've found seems to be different, I'm not sure if that's between open tops, wagons, etc. Regardless, I'm...

Unfortunately no, it seems to be the door that is stuck open and apparently the only way to get to it is to remove the entire dash. It's not worth the time or money to me right now to fix it or get it fixed. If you find another, easier solution, let me know though!

Thank you! I've loved the swap meet section too. Some things were next to impossible to find elsewhere, namely the OEM steps that attach to the factory sliders. Thanks on the switch, it was a hard decision since I used that tray quite a bit, in the end I think I can move past it for the setup haha

Thank you, the switches took a little bit of finese with trimming to get it exactly where I wanted. Slow and steady since I only had one shot haha. You're right about the reinforcement kit, I mixed up the name

Thank you, crazy it was that long ago! It's been good, hope you're doing well too. I need to get out west past Appalachia one of these days. I'd like to see that SAS in action in Moab!

Better late than never!!! Finally, after years of searching I have a Rancho lift on my H3. Took a while to get everything sorted between sourcing parts, vehicles, and just figuring out the overall final plan. About a year and a half ago Rascole hooked me up with H-D tie rods, a locking front...

Better late than never!!! Finally, after years of searching I have a Rancho lift on my H3. Took a while to get everything sorted between sourcing parts, vehicles, and just figuring out the overall final plan. About a year and a half ago Rascole hooked me up with H-D tie rods, a locking front...

Looking to trade some extended leaf springs for stock H3 ride height springs. They're probably an additional inch or two higher than OME leaf springs, so it's really only suitable for someone who has a Rancho Lift or SAS... I need stock (or close to stock) ride height to get this H3 back to a...

So I picked up an entire front diff/axle off of an Adventure packaged I5 from Rascole a while back. It's finally about to be installed, but I have a couple of things I want to verify before I accidentally tell my shop the wrong thing... I understand that Adventure packaged I5's come with a cast...

Very nice set up. If I hadn't spend both arms and both legs on my canvas tent last year, this is something I'd be REALLY interested in doing. Especially because you don't have to remove the rear seats like a saw a lot of people doing years ago

That would be really cool if I could get some better shots and/or measurements. Unfortunately, I think I'll need this mount fabricated within a couple of weeks. H3 is getting sent off to a shop for just a little bit of work and the SPOD will need to be installed and ready for wiring up the front...

Thanks for the install/walkthrough video Acer! Any chance you'd be willing to make a second mounting plate? I just ordered an spod for my lockers and eventual lightbars, the mounting plate is the only thing I'm having issue with finding though. Obviously they don't make anything for the H3, but...